If your Vivo Y20 (Model: PD2034F) is stuck on boot logo, bricked, or facing software issues, flashing the stock firmware can restore it back to working condition. Below are the available official flash files:
📦 Available Flash Files for Vivo Y20 PD2034F
- PD2034F_EX_A_1.71.15_vivo_qcom_Flash_File
- PD2034F_EX_A_6.73.6_vivo_qcom
- PD2034F_EX_A_1.71.8
- PD2034F_EX_A_1.70.19
💡 You can download these files from trusted firmware sources like androidhub.co.in or mifirmware.com (or any verified mirror if links aren’t listed here).
🔧 How to Flash Vivo Y20 PD2034F Using QPST Tool
Follow this step-by-step flashing procedure carefully:
🔹 Step 1: Preparation
✅ Requirements:
- Vivo Y20 Flash File (from the list above)
- QPST Tool (Qualcomm Product Support Tool)
Download QPST Tool - Qualcomm USB Drivers
Download Qualcomm Drivers - USB Cable
- Windows PC
🔹 Step 2: Install USB Drivers
- Install Qualcomm USB Drivers so the PC can recognize the Vivo Y20 in EDL mode.
- After installation, restart your computer for best results.
🔹 Step 3: Put Vivo Y20 into EDL Mode (9008 Mode)
EDL (Emergency Download Mode) is required to flash Vivo Qualcomm devices:
- Power off your phone completely.
- Press Volume Up + Volume Down together and connect it to your PC using a USB cable.
- In Device Manager, you should see:
- Qualcomm HS-USB QDLoader 9008 (COMxx)
🔹 Step 4: Launch QPST/QFIL Tool
- Extract and open the QPST Tool folder.
- Run QFIL.exe (inside QPST tool) as Administrator.
🔹 Step 5: Configure QFIL Tool
- In QFIL, under Build Type, select Flat Build.
- Click Browse next to Programmer Path and select the
.mbnfile from the firmware folder. - Click Load XML, then:
- Select
rawprogram_unsparse.xml - Then
patch0.xml
- Select
- Ensure the firmware path is correctly set in the Search Path field.
🔹 Step 6: Start Flashing
- Click Download in QFIL.
- Wait for the process to complete. This may take several minutes.
- When finished, you’ll see a “Download Succeed” message.
🔁 After Flashing
- Disconnect the phone and power it on.
- The first boot may take 5–10 minutes — don’t interrupt.
- Complete the setup wizard.
🧩 Troubleshooting Tips
| Issue | Fix |
|---|---|
| Device not detected | Reinstall drivers, use another USB cable or port |
| Flashing fails mid-process | Try a different firmware version, verify .xml file integrity |
| Phone stuck on logo after flash | Do a factory reset via Recovery Mode |
| Can’t enter EDL Mode | Use Test Point method (advanced) |