If your Vivo V23 5G (Model: PD2346F) is stuck on the logo, experiencing bootloop problems, or if you just want to reset it to its original factory settings, flashing the stock ROM with the SP Flash Tool is the way to go.
đź“Ą Firmware Download
🔹 Available Flash File:
- Firmware Name: PD2346F_EX_A_14.0.14.0.W30.V000L1_vivo_mtk_Flash_File
- Chipset Type: MediaTek (MTK)
- Format: Scatter-based firmware package
👉 Download from: androidhub.co.in (or other trusted firmware sites)
📲 How to Flash Your Vivo V23 5G (PD2346F) Using SP Flash Tool
đź“ť Step-by-Step Guide
âś… Step 1: Install MTK USB Drivers
First things first, you need to get the MediaTek USB VCOM Drivers installed on your PC. This is crucial because it allows your computer to recognize your phone when it’s in preloader mode.
âś… Step 2: Extract Tools & Firmware
Next, unzip the SP Flash Tool ZIP file into a folder. Don’t forget to do the same for the Vivo V23 5G firmware package. Inside the firmware folder, look for the file named Android_scatter.txt.
âś… Step 3: Launch SP Flash Tool
Now, head over to the SP Flash Tool folder and run flash_tool.exe as an Administrator. You should see the tool’s interface pop up.
âś… Step 4: Load Scatter File
Click on the “Scatter-loading” button located on the right side. Navigate to the folder where you extracted the firmware and select the Android_scatter.txt file.
âś… Step 5: Begin Flashing
Once the firmware is loaded, hit the Download button at the top to get things rolling.
âś… Step 6: Connect the Device
Turn off your Vivo V23 5G. Then, connect it to your PC using a USB cable while holding either the Volume Down or Volume Up button. If that doesn’t work, try connecting without pressing any keys. The SP Flash Tool should automatically recognize your phone and start the flashing process.
âś… Step 7: Wait for Completion
Just sit tight and wait for the flashing to finish. You’ll see a green “Download OK” message once it’s done.
🧩 Post-Flashing Notes
After disconnecting your phone, power it on. The first boot might take around 5–10 minutes, so be patient. Then, complete the setup as if it’s a brand new device.
🛠️ Troubleshooting Tips
| Problem | Solution |
|---|---|
| Flashing stuck or fails | Reinstall the MTK drivers, or try a different USB port/cable |
| Phone not detected | Experiment with different key combinations (Vol+ or Vol-), or use a preloader USB cable |
| Bootloop after flashing | Wipe data/factory reset through recovery mode |
đź“Ą Need Help or More Files?
If you’re looking for
